datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] Delco 10SI Alternator question

To: "Tom @ Datsun2000" <tom@datsun2000.com>, "Datsun-Roadsters@Autox.
Subject: Re: [Roadsters] Delco 10SI Alternator question
From: "Brian St. Jacques" <bstjacques@atrua.com>
Date: Thu, 13 Sep 2007 11:34:53 -0700
Is this why there is often a resistor or resistor wire in parallel with
the bulb? Anyone know how much resistance is typically used there?

Brian
'68 1600 growing closer to SR20DE

-----Original Message-----
From: datsun-roadsters-bounces+bstjacques=atrua.com@autox.team.net
[mailto:datsun-roadsters-bounces+bstjacques=atrua.com@autox.team.net] On
Behalf Of Tom @ Datsun2000
Sent: Thursday, September 13, 2007 11:13 AM
To: Datsun-Roadsters@Autox. Team. Net; Matthew A. Smith
Subject: Re: [Roadsters] Delco 10SI Alternator question

Matt,

I have a GM alternator in Mr. Hyde.  If I remember correctly the idiot
light is the excitation lead.  I played with several bulbs in this
circuit and found that some caused the alternator to require a lot of
revs before it would come to life.  I finally ended up with a #53 bulb,
which requires a few RPM to start charging the battery, but it is a good
compromise for me.

Tom
69 2000 - Mr. Hyde
Portland
http://www.datsun2000.com
http://www.nowroc.org


        On 9/12/2007 8:34:17 AM, Matthew A. Smith
(matthews517@earthlink.net)
wrote:
> Hi All,
>
> Long time no see!
>
> I have been running a 10SI alternator on Loreli for several months
now.
> Here's the issue. At idle (approx 700 RPM), the alt doesn't put out
> enough power to fully power the headlights. My solution was to put a
> smaller pulley on the alt. This seems to have worked OK. (FYI, this is

> no easy task.
> That
> nut is on there REALLY TIGHT!!!)
>
>
>
> My question involves the wiring for the alt. I have a 10 ga wire going

> to the battery from the alt stud. I have a 10 ga wire going from the
> alt stud to the #1 terminal on the alt (yes, yes, everything I've seen

> says it goes to the #2 terminal). I have an idiot light going from the

> + side of the
coil
> to the #2 terminal. I also have a 10 ga wire going to the original red
BATT
> wire for the stock alt (thru a 30 amp maxi fuse as suggested on
> 311s.org) just to cover all my bases.
>
>
>
> Why does my alternator work wired like this and not when wired
correctly?
> i.e. alt stud to #2 and idiot light to #1? When looking at the alt
> from
the
> rear, the case is marked as #1 on the left (it's also marked with an
________________________________________

bstjacques@atrua.com

Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters
________________________________________


Datsun-roadsters mailing list

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/datsun-roadsters

<Prev in Thread] Current Thread [Next in Thread>