I had a similar problem years ago, finally cut a section out of the damn thin
g, put in a smaller pipe inside, and made it narrower. Never did roll over
so don't know if it would have worked, and later sold the bar.
Gary C
In a message dated 6/25/2007 10:09:06 P.M. Pacific Daylight Time,
doctor_evil@fastmail.ca writes:
Hey everybody
I just got an autopower rollbar today, and I just dropped it in my low
windshield car.
It appears that the rollbar and the top are incompatable, as when I try to
put the top back, the frame hits on the rollbar on the sides. It appears that
the rollbar is about 3" too wide.
Does anyone have any experience with this? Is there some fix to get it to
fit?
Help?
Dave
67 2000
_________________________________________________________________
|