Is it just me?
Is it a bad tool?
I have a hard time getting my (pneumatic) grease gun to prime when I
change cartridges. I have to take a wad of grease and cram it into the
pit where the pump piston lives, fill the remainder of the head and
swirl it all around to make sure I got all the air bubbles out. I then
mate the tube with the loaded cartridge so that the new grease meets the
grease I slobbered into the head without an air pocket and screw the
tube to the head. If I'm lucky, it'll prime.
Am I doing something wrong?
James -
|