Gary,
Its looking real good - can't wait to see all the panels in that yellow!!
Mark Sedlack
ZROC
Cuyahoga Falls OH
66 1600 http://www.mildevco.net/chevypowereddatsuns/
77 280Z http://www.mildevco.net/chevypowereddatsuns/
----- Original Message -----
From: "Gary Tew" <garytew@cox.net>
To: <datsun-roadsters@autox.team.net>
Sent: Monday, August 07, 2006 8:25 PM
Subject: fender mounting
> Ok boys and girls, progress has been made! After waiting for my painter
> friend to free up some time in his shop. I decided to jamb stuff out
> and get on with it. So, this morning, I painted the back of the front
> fenders, hood, deck lid and door jambs! Later this week, I 'll tackle
> the engine compartment, and rear fender wells. Then, I'll put the body
> back on the frame and roll it outside to do the trunk and cockpit. I'll
> let you know when new pics are up on the website. Finally to my
> question. When mounting the front fenders, does just the fender washer
> go on top with the screw and a lockwasher and nut on the bottom? Also,
> I had the door hinges zinced again and I'm considering not painting
> them. Did Roadsters come with painted door hinges? And finally. For
> any Z guys out there. I need to know the metric thread size for a
> Z31clutch slave cylinder. I need to adapt that to the standard Roadster
> flex hose or go have a custom one made. Again, thanks always for any
> assistance. Man my garage is hot!!
>
> Gary Tew
> Peoria, AZ
> early '67 1600 (VG30)
> www.members.cox.net/garytew
|