I am running "Aurora" wires on my car.
http://www.auroraignitionwires.com/IgnitionWireLnk.htm
>From what I have read and heard, any good quality set should be sufficient
(Napa). I don't think there is any reason to buy any exotic wires (including
aurora. I needed a custom set, and they made them for me while I waited
patiently at their counter. Nice folks, easy to talk too and helpful.)
I rercently read an article in Grassroots Motorsports (June 2005) that
recommends between 100 and 1000 ohms resistance in each spark plug cable and
non-resistor plugs.
They also mention with an ignition upgrade you may want to go one range
colder on the plug...?
With Gary's setup you should open up the gap some as well, as I'm sure he
recommends.
Cheers
Daryl
----- Original Message -----
From: "Mike H." <twobeaners@earthlink.net>
To: "Datsun-Roadsters@Autox. Team. Net" <datsun-roadsters@autox.team.net>
Sent: Wednesday, June 29, 2005 9:41 PM
Subject: Plug Wire Recommendations
> Hi Listers,
> I just received my new Boone dizzy. I'm planning on starting with the
> Blaster-2 coil (no MSD 6A for now). Any recommendations, comments, or
> other
> info on what plug wires would compliment this ignition setup?
> Who's runnin' what?
> Thanks,
> Mike Hudson '67-1600
|