Hi, all. i'm usually in lurk mode, but i've got a bunch of questions!!!!
1. i'm pulling the engine, and have noticed the leads going to the reverse
switch look identical. are they? does it matter which one goes where?
2. where do i get a clutch alignment tool?
3. i am documenting this, and was wondering if there is a basic photo
program that will allow me to put circles and arrows on pictures (and maybe
resize/crop, although i use LView for that)
4. dean's book says to disconnect the driveshaft from the differential and
then pulling it from the transmission. i can't see much; i guess it would
help to pull the tranny mount etc., so you just pull it out????? i have
already drained the tranny oil.
5. the windshield looks like two big bolts each side; then that metal rod in
the middle - you disconnect that from under the dash?
6. finally, for now - pulling the dash out to refinish it - you have to
pull all the instruments, and what else????
http://www.sumton.com/daves/cars/datsun/engine/engine1.html
and
http://www.sumton.com/daves/cars/datsun/body/body.html
|