Hi Sid (and sorry about the wasted bandwidth to all!),
Felt guilty about misreading your post so I went and pulled a stud from
my engine and measured it.
The upper water pump stud is 4-1/8 inches long, and is 8mm diameter
(thin). Metrics! 8mm x 1.25 thread. The engine block side is threaded
7/16 inch length, while the water pump side is threaded 3/4 inch length.
I couldn't easily get to the lower stud (thicker), but it should be the
same length, although it is a 10mm diameter stud, and it is threaded for
a 1 inch length (as 10mm x 1.25 thread) on the water pump side. And that
is a standard tap/die combination.
Fred
(now I will go sleep)
-----Original Message-----
From: owner-datsun-roadsters@Autox.Team.Net
[mailto:owner-datsun-roadsters@Autox.Team.Net] On Behalf Of roadster
katman
Sent: Thursday, November 04, 2004 2:39 AM
To: 'sidney raper'; datsun-roadsters@Autox.Team.Net;
rlporter@m-insights.com; rlporter5@comcast.net
Subject: RE: Need a couple of studs and nuts
Hi Sid,
Forget what I said. It's late, and I misread your post - WATER PUMP.
Thought you meant the water thermostat housing studs. I don't have a set
of the water pump studs handy.
Sorry - Fred
(now to get some sleep!)
|