Of course, this is all for my PL411, not for my Roadster, but these
parts are pretty similar. The front studs are 1 5/8" from start of
knurl to end of threads, which is 1/8" less than the rear studs. The
only studs I've been able to find online are either nearly as short as
mine (up to 1 3/4" in length) or are much longer, 2 3/4" long. I
haven't found any that are in between, EXCEPT one in Australia,
measured in mm, that is for the rear disk of a Holden, that have about
the correct knurl diameter (mine are approx. .438" in diameter) and are
just a hare under 2" long. If anyone has a wheel stud lying around and
some calipers, could you measure the knurl for me?
Does anyone know of studs of the correct length available state-side, or
do I have to order from Australia, or cut 2 3/4" studs to 2"?
|