Keith,
Thank you for the tip. The pushrod wire used for the servos on Radio
Controlled model airplanes worked very well for my Heater controls.
James & Susan Richards
<mailto:jmr407@mindspring.com> jmr407@mindspring.com
-----Original Message-----
From: Keith0alan@aol.com [mailto:Keith0alan@aol.com]
Sent: Sunday, August 22, 2004 8:53 PM
To: jmr407@mindspring.com; datsun-roadsters@autox.team.net
Subject: Re: Heater Control Cables
Hello all,
To replace the insides go to the hobby store and get some .055" music
wire. It is an exact match. The curlies on the ends and be bent around a
couple of about # 10 screws clamped in the vice. I've replaced a number of
them and it works fine. Don't forget to oil up the insides of the housing.
keith
Dear Group,
Looking for creative ideas on what can be used to replace the control
cables for the three heating control levers. The jackets for each of
the cables are in good shape. The offset bend on two of the cable ends
look like they broke off.
James & Susan Richards
jmr407@mindspring.com
|