I recommend using a CRC product called Maniseal.
Can be used to seal kilns etc. so engine exhaust is easy peasy.
It is a tan coloured paste in a squeeze tube.
Apply it in a continuous bead around all openings, bolt up the manifold(s)
and run the engine.
The engine heat will cure the sealant and barring untrue surfaces, should do
the job nicely!
Regards,
Graeme Suckling
1965 SP310 - under construction DSOA Member # 112
1971 P510 4 door - daily driver, original owner.
1972 PL510 2 door - VG30ET on Autogas.
1973 HS30/240Z - re-building to 2004 specs.
http://www.imagestation.com/album/?id=4290669159
Adelaide, South Australia.
Subject: datsun 2000 header and intake gasket install
Hello to the group and thanks for past help,,,,
when installing a new gasket for intake and exhaust, using a aftermarket
header,
Question: is should i use gasket cement etc, with the new header gasket as
the water
jackets had a leak with the new gasket on the intake manifold leaking on the
headers
i know some gasket sealers are high heat and may help solve this problem,,
thanks again
Ron Mistak
68 2000
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.659 / Virus Database: 423 - Release Date: 15/04/2004
|