Thank you for acknowledging me and you are welcome to visit the shop anytime
you please. Ed Johnson is the man Stan is refering to. His number is (818)
554-5008 Dean
Stan Chernoff <az589@lafn.org> wrote:For what it's worth, I already
corresponded with Sid prior to his request
to the list. After I got my car running I took it and a box full of jets
to a shop that was good with these carbs. The car ran OK after he was done
and I paid his price. Timing setting was also required to make it work.
Every engine is somewhat unique. Displacement, cam design, compression
ratio, porting, manifold design, valve sizes and ignition characteristics
are among the many variables that are related to carb setup. Carb size and
choke size are some of the other variables that must be considered. Nissan
sold 50mm carbs and manifolds for 1600 roadster engines at one time.
It may help to read and understand the setup and troubleshooting sections
of the Mikuni PHH Carburetor service manual to get a start. It may also be
necessary to pay someone to do the final dialing in.
There is a person that works within doors of Dean's shop that has set up
pushrod Mikuni carb engines that Dean could ask and relay the information.
Stan
=============
At 06:28 PM 2/24/2004 -0800, datsun parts.com wrote:
>I believe Stan has knowledge concerning this. He may be able to help you!
Dean
>
>sidney raper wrote:I know that there are a few solex
1600s out there, but there is very little
>information that I have found about them. Does anyone with a solexed up
>1600 want to share their jetting setup? I recognize that every car is
>different, and that is fine. I am looking to see if there is a baseline
>from where I can start.
>
>
>
>Sidney Raper
>1964 1500 (still a project.... sigh....)
>1967 SRL311 00076 (alive again!)
>Jacksonville Florida
---------------------------------
Do you Yahoo!?
Yahoo! Mail SpamGuard - Read only the mail you want.
|