Stan-
I'm using ARP studs for the head and main caps. Head studs get torqued
to 65 ft-lbs. I got the ARP part numbers from the mailing list. There
was a post here within the last couple of years. Should be in the
archives. I'm using ARP bolts and studs just about everywhere on the
engine. Even found a crank bolt for a Pontiac that works great on a
3-main, but you have to cut a little off the end of the bolt.
Chris
On Thursday, September 11, 2003, at 08:20 PM, Stan Chernoff wrote:
> Hi Chris,
>
> That sounds good especially since you are running 12.5:1 compression.
> Do
> you also use the 7/16 X 5" +/- studs from ARP that originally were
> made for
> Chevy's? They seem to help keep gaskets in place too.
>
> Stan
> ================
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|