I ran the page through the Alta-Vista Bablefish translator, and the caption
says ( in fractured translation)
" Usually our company hides the large hit commodity where
the TOPY make normal iron ? ? it is the wind
In order to wear the aluminum 14 inch 6j,
The caliper - outer circle a little cutting,
Also the offset being normal, way it can go, the caliper -
Being middle, one time dividing, from center shaving being packed
Adjusting it is corrected. "
So, is, don't you think? the caliper of the ? - the Z32 -
That way when you think it is attached with a pop, the Oma difference!
Variety processing are necessary, don't you think? the ? -
It sounds kinda like the original SRL manuals, don't you think?
Mark
----- Original Message -----
From: "alvin gogineni" <alvingogi@hotmail.com>
To: <datsun-roadsters@autox.team.net>
Sent: Saturday, April 19, 2003 5:08 PM
Subject: Z32 caliper Conversion!
> I didn't know you could do this, but some one already has, check it out.
> Site also has some wild roadsters with flares.
> http://www3.coara.or.jp/~ksgarage/f_lady/rose/rose.html
>
>
>
> Alvin Gogineni
> San Jose, CA
> 67.5 1600/U20
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|