Here is what I'm trying to do, I have a KA that is very close to being
drivable but I need to make a water by-pass that goes between the thermostat
and water outlet. I found the perfect set up but I need to know if it can
take the heat of the motor.
What I want to do is use houshold copper tubes, I know the joints can take
the temp from the hot water heater but can they take the temp from the
engine. I dont want solder to melt out with engine temps up around 220
Ken
DATSTER
Pleasanton,Ca
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|