John,
A look at the factory parts manual shows the notch towards the front. When
I rebuilt mine about 6 years ago and I seem to remember tht the notch was
also towards the front.
Peace,
Pat
- Support Habitat for Humanity, A "hand up", not a "hand out" -
Pat Horne, Network Manager, Shop Supervisor/Future planner, CS Dept,
University of Texas, 1 University Station C0500,Austin, Tx. 78712-1188 USA
voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
On Wed, 2 Apr 2003, John F Sandhoff wrote:
> I have a 4-speed partly apart to replace the ground-up countershaft
> and bearings. Well, actually I've pulled two of them apart in order
> to build back one that will hopefully work right :-). And in so doing,
> I found that the countershaft can go in either way, as I had one each
> way! So should the notched end go towards the FRONT (which allows
> for pulling the shaft without major disassembly), or does it go towards
> the BACK (which is what I found in the tranny I don't think's been
> rebuilt before)?
>
> -- John
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|