I found this very interesting but why not make the
engine block with "wet" cylinder liners? Unless
originality is an issue of course. They had to make
offset connecting rods for the big bore block as
cylinder spacing is different. Lot's a work!!!
Thomas
Gordon Glasgow wrote:
> Good Lord, what a project! Any moldmakers out there who want to do U20
>cylinder
> heads?
>
> Gordon Glasgow
> Renton, WA
>
> > -----Original Message-----
> > From: owner-datsun-roadsters@autox.team.net
> > [mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of datsunmike
> > Sent: Sunday, December 08, 2002 5:25 PM
> > To: Steve & Virginia; Rich Glass; Mike Jennings; Joe Curto; Datsun
> > Roadster List; Bill Strohm
> > Subject: So, ya wanna build an engine?
> >
> >
> > Check this out.
> >
> > http://www.acmefluid.com.au/larry/dmd1.html
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|