The clutch has nothing to do with the tranny not shifting as long as the
motor is off that is. I suspect someone disassembled the rear housing and
didn't line up the shifter shaft correctly upon reinstallation and thus it's
not engaging the shifter rods.
Didn't you mention previously that it wouldn't shift into any gear?
Mike
----- Original Message -----
From: "SlowBoy" <slowboy@cox.net>
To: <datsun-roadsters@autox.team.net>
Sent: Wednesday, October 09, 2002 5:26 PM
Subject: Tranny No Engage
> Need some advice. Finished putting in the 4 Speed to test it out.
(Unknown
> driving condition of four speed, but had no visible defects and and no
slop.)
>
> I was lucky as the car started right up when I was done, but, the tranny
does
> not engage in any gear. Soooo, what would cause that? If adjusting the
> clutch is an answer, how do you do that?
>
> Thank you!
>
> //
> //
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|