Hi Pat,
yes I have read the same "description" and I think it is Japenglish
for "cam chain tensioner".
There is a really good giggle in reading some of the old manuals and
even translating some of the Web classifieds!
-----Original Message-----
From: owner-datsun-roadsters@autox.team.net
[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of Patrick J.
Horne
Sent: Sunday, 29 September 2002 9:48 AM
To: datsun-roadsters@autox.team.net
Subject: 1600 timing component question
I am in the process of replacing the timing gears and timing chain on
my
67.5 1600 and found in the Clymer manual a statement that there is
supposed to be an O-ring between the teeth on the crank gear. I've
replaced 2 timing sets over the years before this one and none of them
had
this O-ring. IS there supposed to be one? The factory parts manual
doesn't
show one. The manual indicated that its purpose was as a tentioner
(doubt
it) and as a means of quieting the chain (possibly). Anyone know for
fure?
Another thing I found on this chain job. When I removed the timing
cover I
found that the tensioner was wanting to be replaced. In fact, it had
already started taking itself off for me! Bot bolts were loose and the
tensioner was sitting crooked. There are worn sopts on the inside of
the
cover where the bolts have been rubbing. Good thing I bought a
replacement!
Peace,
Pat
- Support Habitat for Humanity, A "hand up", not a "hand out" -
Pat Horne, Network Manager, Shop Supervisor/Future planner, CS Dept,
University of Texas, 1 University Station C0500,Austin, Tx. 78712-1188
USA
voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|