Alvin,
Sweet car! Thqanks for posting the pictures.
What do the Sparco harnesses cost?
I think you have the shoulder harnesses threaded through the adjusting
buckles backwards. To hold best the end you pull on should be between the
harness under tension and the buckle. I suggest that you check the
instructions. The webbing is correctly threaded on the lap belt though.
Peace,
Pat
- Support Habitat for Humanity, A "hand up", not a "hand out" -
Pat Horne, Network Manager, Shop Supervisor/Future planner, CS Dept,
University of Texas, 1 University Station C0500,Austin, Tx. 78712-1188 USA
voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
On Wed, 18 Sep 2002, alvin gogineni wrote:
> www.picturetrail.com/alvin6
> Everything was going smooth until I had to mount the shoulder harness. Both
> lap belts bolted up fine. I thought I would bolt the third point on the rear
> fender hump, where the high windshield cars do so. I checked, and there was
> indeed a hole beneath the vinyl, but it wasn't threaded or deep enough, so
> I'm SOL. So post '67.5 cars only have this hole threaded for belts? In the
> meantime I'll use the lap belts. Check out the pics. Peace
>
> _________________________________________________________________
> Chat with friends online, try MSN Messenger: http://messenger.msn.com
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|