Just squeeze down on the female end a bit to tighten up the fit... used to
happen to me all the time too.
Greg Burrows
Ryan Bird wrote:
> Hey Folks,
>
> I have a nagging wiring issue I could use the collective genius of the group
>to solve. My ignition wire that connects to the starter has a nasty habit of
>sliding off. I took the starter out last week and re-wired the bugger, put a
>new (unshielded) female head connector on the wire, but after a morning of
>zipping around town, the car refused to start... (With all other electrical
>components happy.) I am sure the wire slipped off again. (Did not feel like
>getting under the car is 100+degree weather.) So, on to the question.
>
> How the heck do I make it so this silly wire stays on? (While still being
>able to take it off)
>
> Thanks,
>
> Ryan Bird
> 67 1600
> www.azroc.org/ryan
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|