Continue to try penetrating fluid and putty knives. Also a little heat might
help, like from a propane torch. Be patient ..It could take a while and you
could crack the housing eventually.
Mike Koken
Colo Springs
----- Original Message -----
From: "Ryan Bird" <birdman@myrealbox.com>
To: <datsun-roadsters@autox.team.net>
Sent: Sunday, August 25, 2002 1:15 AM
Subject: Question from my WebSite
> Hey folks,
>
> I replied to Darren, but if any of you have any comments, I am sure he
would like to hear them as well. You could even invite him to join our
happy little club.
> -------------------
> Hi, love your web stuff on your rebuild. I have a 67.5 1600 like yours,
but in better shape than when you started. Right now however I am frying my
engine as the thermostat is bad. Unfortunately I can't get the housing off.
The best I can tell is there are two posts that the housing is mounted on
and the housing should just slip on and off the two posts. However, I can't
get the housing to slide up and off. Is my assumption correct or am I way
off base? Any technical advise and suggestions you can lend would be
appreciated. Darren
> --------------------
> His email address is:rossfamily@cnonline.net
>
> Happy Roadstering!
>
> Ryan Bird
> 67 1600
> www.azroc.org/ryan
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|