MSD makes several coils. 8203 and 8200 seem to fit the bill. I would check
the MSD website for ballast info. You need to run at least 1 ohm of
resistance for the Pertronix setup.
www.summitracing.com usually offers the best prices.
Mike
----- Original Message -----
From: "Guy & Pamela Pepoy" <gppepoy@cybertrails.com>
To: "Mike" <datsun_sports@hotmail.com>
Cc: "Datsun Forum" <datsun-roadsters@autox.team.net>
Sent: Tuesday, August 13, 2002 10:51 PM
Subject: Re: coil
> Hi, I know this was covered ad infinitum ad nausium a while back.
> However, my computer burped and I lost some of my precious saved
> messages. I have a stock distributor on my 1600. I will be installing
> the Pertronix ignition. What MSD coil should I purchase. Who is
> selling them. Many thanks.
> Guy
>
> Mike wrote:
>
> >hi,
> >
> >I just got my EI converted coil in today from Gary. thx Gary! I want to
use
> >the MSD blaster II coil. however I have a question. it says not to mount
the
> >coil horizontally as the oil will not cover the windings all the way.
anyone
> >else using these and does the 280zx bracket mount the coil vertically?
> >
> >thx again,
> >
> >mike
> >
> >/// datsun-roadsters@autox.team.net mailing list
> >/// Send admin requests to majordomo@autox.team.net or go to
> >/// http://www.team.net/cgi-bin/majorcool
> >/// Send list postings to datsun-roadsters@autox.team.net
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|