I'm having difficulty getting my extractors to fit
properly and not leak. It was suggested that I
replace my single gasket with a thicker one made of
two gaskets that have coppercoat in between them - so
I have bought extractor gasket material (with a metal
layer) and slowly cut out two new exhaust manifold
gaskets.
Before I fit this monster of a gasket, does anyoe on
the list have any advice on this. My head is clean as
are the faces on the extractors. I tried tightening
the nuts as much as I could but to no improvement.
Marko
64 1500 with R16
http://digital.yahoo.com.au - Yahoo! Digital How To
- Get the best out of your PC!
/// datsun-roadsters@autox.team.net mailing list
|