Not to mention flat thumbs and fingers!!!
Ron
>
> From: "datsunmike" <datsunmike@nyc.rr.com>
> Date: 2002/08/02 Fri AM 06:31:47 EDT
> To: "aaron atkins" <amatkins@qnet.com>,
> "datsun roadsters"
> <datsun-roadsters@autox.team.net>
> Subject: Re: Metal working
>
> Easy? Hardly. It takes years to master the equipment. There's a shop not too
> far from my house and the guys were trained by RRoyce in using the equipment
> you mentioned. These guys are pros.
>
> They let us try it and it was a lot harder than it looks.
>
> Mike
>
> ----- Original Message -----
> From: "aaron atkins" <amatkins@qnet.com>
> To: "datsun roadsters" <datsun-roadsters@autox.team.net>
> Sent: Friday, August 02, 2002 6:06 AM
> Subject: Metal working
>
>
> > I just picked up a book that every car person should have. "Ultimate
> Sheet
> > Metal Fabrication". It talks about English wheels and hammerforming, and
> > all this cool stuff that will take me a week to digest. I never realized
> > how easy it is to do the stuff the pro's do (at least they make it sound
> > easy". If you get a chance check it out. Very informative book on the
> > basics of working in sheet metal relating to cars.
> >
> > Roadster content.
> > Hand-hammered fender flares here I come.
> >
> > Aaron A.
> >
> > /// datsun-roadsters@autox.team.net mailing list
> > /// Send admin requests to majordomo@autox.team.net or go to
> > /// http://www.team.net/cgi-bin/majorcool
> > /// Send list postings to datsun-roadsters@autox.team.net
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|