In a message dated 5/30/2002 12:07:50 AM Pacific Daylight Time,
alvingogi@hotmail.com writes:
> I'm designing an independent rear end (loosely based on the Jag) for a
> Datsun roadster using AutoCad. Has anyone done this before, and if so did
> it
> work out alright?
I got some remnants of a custom IRS subframe that I welded up that I can dig
up if you want to use it (tho I was going to mount a little 3hp motor to it
and make it into a gokart). I was using Z32 hubs mounted on custom aluminum
uprights attached to custom control arms with shortened Z32 axles. Problem
with most roadster IRS conversions:
1) clearance with frame rails (not a prob if you chop them)
2) COST!!! $$$$
\/ /\ /\/
personal quote - "\/\/ O \/\/ !"
/// datsun-roadsters@autox.team.net mailing list
|