Richard,
I know the answers for you:
1) the holes are for the factory hardtops
2) the bracket is for the factory hardtop holddown
3) the bracket is for the exhaust manifold brace
Sid
>From: "reblues" <reblues@reblues.net>
>Reply-To: "reblues" <reblues@reblues.net>
>To: "'Datsun Roadsters'" <datsun-roadsters@autox.team.net>
>Subject: Looking for Enlightenment
>Date: Tue, 14 May 2002 13:27:14 -0400
>
>Here are a few questions I have wondered about for years.
>
>These are on my 68 roadster.
>
>1. In the molding where the tops sit, just behind the mounting brackets,
> there is a hole on each side of the car. What are these for?
> My quess. Support bar for the tonneau cover.
>
>2. Underneath the ledge that the same molding sits on, in the back center,
> there is a mounting bracket with 2 treaded holes. What is this for?
> My quess. Absolutely none
>
>3. On the back of the alternator mount on the drivers side, there is a
> protrusion with a bolt hole. What connects here.
> My quess. A brace for the manifold.
>
>
>As you can see, it doesn't take much to Enlighten me. If I can get these
>questions answered then maybe I'll move on to the meaning of life or which
>goes better with Tequila, Corona or Petes Wicked Ale?
>
>Thank You
>Richard Brown
>reb@reblues.net
>
>/// datsun-roadsters@autox.team.net mailing list
>/// Send admin requests to majordomo@autox.team.net or go to
>/// http://www.team.net/cgi-bin/majorcool
>/// Send list postings to datsun-roadsters@autox.team.net
>
_________________________________________________________________
Join the worlds largest e-mail service with MSN Hotmail.
http://www.hotmail.com
/// datsun-roadsters@autox.team.net mailing list
|