Chris
I use an exacto knive to cut the slits/holes for the clips. I usually do it
with the top partially installed (snaps to top bow) so I can see where each
twistie clip goes. Then push the clip against the fabric and leave a small
indentation. Then cut the holes/slits where the indentions where left.
needle nose pliers will secure the snap to the fabric. Do one lift a dot at
a time and check from the right to the left side to make sure everythings
even. Finally do the top bow. Again this requires fitting and refitting
before you make the final cut and screw on the retainer plate. I probably
have instructions from a crown top if you need it.
Mike koken
Colo. Springs
----- Original Message -----
From: "Chris Gray" <grayc@rpi.edu>
To: "Datsun Roadster List" <datsun-roadsters@autox.team.net>
Sent: Tuesday, February 19, 2002 8:33 AM
Subject: Soft Top Installation (Twisties and Posties???)
> I just got my soft top and it *looks* great! BUT, I dont know if there is
a
> specific way to put on all the little metal clips. Is there a specific
way?
> The top did not come with directions...
>
> Thanks, Chris
> www.rpi.edu/~grayc
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|