List,
I just got a new locking gas cap. What is the trick at getting to the
pins to re-key the lock. Normally the cylinders just slide out, but
this doesn't seem to be the case.
Dana
Patrick J. Horne wrote:
> The lock is held to the steering column with 4 bolts that have no slot or
> flats on them to get them out. When thew were installed they had
> extensions on them that twist off under torque. There are two ways that I
> have used to get them out. One is to use a cold chisle on them, using the
> chisle to turn the bolt heads. The other is to use a moto tool, or other
> grinder to cut a slot in each bolt head, then use a screwdriver bit to
> back them out. The correct bolts should still be available from the
> dealer, or you can just thread in some standard bolts or screws, but this
> just makes it easier for someone to remove the column lock.
>
> Peace,
> Pat
>
> - Support Habitat for Humanity, A "hand up", not a "hand out" -
>
> Pat Horne, Network Manager, Shop Supervisor, Future planner
> CS Dept, University of Texas, Austin, Tx. 78712 USA
> voice (512)471-9730, fax (512)471-8885, horne@cs.utexas.edu
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
>
>
>
--
Dana Nojima, Ph.D.
HYSEQ, Inc.
Cell Biology Group
675 Almanor Ave.
Sunnyvale, CA 94086
(408) 746-4567
noji@sbh.com
/// datsun-roadsters@autox.team.net mailing list
|