You bend the little spoon like part that contacts the float needle. Remember
to measure when the float lever just touches the needle and doesn't push it
down. Good eyes and patience are definitely required.
Took me quite a while to get it right but I'm old and blind :)
Mike
----- Original Message -----
From: "Adam Bradley" <ambradley@yahoo.com>
To: "Toshiyuki Sasakado" <sasakado.toshiyuki@ssd.loral.com>
Cc: <datsun-roadsters@autox.team.net>
Sent: Monday, February 11, 2002 6:08 PM
Subject: Re: Adjust float levels in a 1600
> Thank you for the link! The one thing this doesn't tell me is how to
> adjust the float bowl lever. Do I just bend it so that the fuel
> stabilizes at the same level in both carbs? (23mm below the top of the
> float bowl) Or do I bend/adjust something else?
>
> Thanks again!
> Adam
>
>
> --- Toshiyuki Sasakado <sasakado.toshiyuki@ssd.loral.com> wrote:
> > Adam,
> >
> > Check this site:
> > http://www.jetlink.net/~okayfine/sutech.html
> >
> > Toshi
> > '66 1600
> >
> > Adam Bradley wrote:
> >
> > > Could someone please post the instructions for adjusting the float
> > > levels in a 1600? Things such as what to bend/adjust, what level
> > the
> > > gas should be at when full, etc...
> > >
> > > =====
> > > Adam
> > > '70 1600 SPL311-28181
> > > http://www.picturetrail.com/abend
> > > Send FREE Valentine eCards with Yahoo! Greetings!
> > >
> > > /// datsun-roadsters@autox.team.net mailing list
> > > /// Send admin requests to majordomo@autox.team.net or go to
> > > /// http://www.team.net/cgi-bin/majorcool
> > > /// Send list postings to datsun-roadsters@autox.team.net
> Send FREE Valentine eCards with Yahoo! Greetings!
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|