The pistons will slide "smoothly" but not necessarily, "easily". You don't
want them flopping around in the bores. NOTE: be careful if trying to relieve
a "stuck" piston. There is a central pin smack dab in the middle of the
housing that the piston rides on. You really dont wanna mess that up !
A good way of loosening a stuck piston is to modify an old bleeder screw (
drill down all the way through the center) and tap to take a grease-gun zerk.
Pump it full, and watch the piston pop loose.
When you're done - be sure to install some "speedbleeders" they make life
much easier for ya'
Laurie :-)
70 SPL311
AzROC
Chandler, AZ
/// datsun-roadsters@autox.team.net mailing list
|