In a message dated 8/27/01 4:21:21 AM !!!First Boot!!!, SLBESQ@aol.com writes:
<< has anyone out there ever attempted to take the side moldings off a 67.5?
the little screws are too tight to unscrew, and are pretty much laughing at
my cobalt, "made-for-hardened-steel" drill bits. i drill for about 60
seconds and almost no metal is removed. the bits are brand new. >>
Hello,
If the nuts are stuck on that tightly I would suggest the you use a Dremel
rather then a drill. You will find that a cutting wheel will take care of
business fast. Good luck on the other hard to reach ones.
Calspeed
Calspeed
|