Hi Bill,
When you bleed the front brakes be sure to whack the cylinders to get the
air out. Use a plastic or rubber hammer (or a block of wood and a regular
hammer) and rap the cylinders smartly to dislodge the air. The front
brakes are a licenced SOB to bleed!!!
Fred
William Schairer wrote:
> --
> So I have been doing a lot of reading of datsun email but this is my
> first request for help.
>
> I had my roadster up on jackstands to replace the slave cylinder so I
> decided I would go ahead replace the master cylinder, since the slave
> cylinder was so easy.
>
> I was also going to replace the flexible brake lines while I was at
> it. I couldn't loosen a couple and couldn't really figure out how to
> get them off anyway so I decided to let that job wait for another
> day. I did have to undo a couple lines on the front left wheel in
> order to get some vice grips on the bleeder valve that was stuck.
> When I put it all back together I couldn't seem to keep one line from
> leaking where it tied into the brake cylinder. It finally seemed to
> stop leaking so I set forth on the task of bleeding the system.
>
> First I bled the new master cylinder. Then I bled rear right, rear
> left, front right and finally front left. When all done the pedal
> goes to the floor and the brake failure light comes on. The rear
> brakes lock up but nothing up front. More bleeding...still no brakes
> up front.
>
> At this point I decided the new master cylinder wasn't functioning
> properly (a friend of mine who is a power wagon nut had told me he
> has problems with new parts far too frequently). So, I took out the
> new master cylinder, cleaned up the old one and reinstalled it.
> Re-bled everything. Still no front brakes. Checked Chiltons trouble
> shooting sections and it says one reason the brake light will glow is
> due to "failure to center combination valve or proportioning valve."
> I figure I have solved my problem because I never "centered" anything.
>
> Go to the brake section and it says nothing about centering the
> proportioning valve and in fact says that it can't be adjusted. If
> it isn't working it has to be replaced. I called my power wagon
> friend and he has no idea except that I must have air trapped in the
> system somewhere. So I bleed again. Still nothing up front.
>
> So what happened? Did I mess something up or did I just get lucky
> that they failed on the stands instead of on the freeway? I
> desperately want to get this thing going again as it has already been
> down a couple months with a blown head gasket which I think I finally
> got fixed. Coolant has been staying put for the first time since I
> got the car and the temperature seems to holding ok. Want to get the
> brakes working so I can make the Palomar run.
>
> Thanks,
>
> Bill
> 70 1600
> san diego
--
Best regards,
Fred Schroeder
'70 2000
SRL311-13359
|