Breaker plate - RE: Dwell vs Gap

["Brian Hollands" <bholland@hayes.ds.adp.com>]

Here's a question for the group.  The solid distributor plates are NLA from
Nissan Comp but I know that you can braise the 2 piece plate together.  How
exactly is that done?  Braise it with silver solder?  So that it is oriented
the same as it would be with the vacuum advance hooked to it but
disconnected?
How do they wear?  I never knew that they did.
Brian

-----Original Message-----
Make sure you get a new vacuum plate also as they
wear quickly.