You will need to drill out the holes the studs go through to accomadate the
slightly larger 12mm studs. Not sure exactley what drill size to use, I
used a 1/2" an my impression is that it was ever so slightly too large.
The studs on the rear are flat on one side so you need to buy the two types.
The Z wheels I use require a lug nut that has to come from Nissan, about $5
apiece, I never could find an aftermarket nut that would work. Different Z
wheels may accomadate different lugs though.
In short, it was a bigger job than I thought it would be but I'm happy with
the wheels.
Ray
68 1600
68 2000
At 12:31 PM 04/07/2001 -0400, Alan Vedadi wrote:
>I need to convert my Wheel studs from the 7/16" to 12 mm, to fit Nissam Z
>alloy wheels. I would like to know what I am getting into and the degree of
>difficulty.
>
>Is there any web link that describes the procedure?
>
>TIA
>
>Alan Vedadi
>1967 1600 SPL-311
>Potomac Maryland
>
>_________________________________________________________________
|