Patrick J. Horne wrote
>I am getting ready to have my ignition lock/switch overhauled and I
>don't see how to pull the lock out. This is on a 67.5.
>
>Thanks,
>Pat
Does the 67.5 have the dash-mounted switch? If so there should be a
hole about 3/32 inch in dia. on the barrel of the lock. Insert a piece
of music wire, or the non-business end of a small drill into the hole,
and you should feel a springy resistance. With the mounting hardware
off, push the wire or drill in, and gently pry the tumbler assembly out.
There should be a little ledge to allow a small prying tool. It might
take some wiggling, but it should slide out.
The column mounted locks are much more tamper-proof, you'll probably
have to remove the tumblers L.A. style...with a slide hammer ;-)
Marc T.
==========================================================================
Marc Tyler
TDROC
1970 1600 #SPL311-31016
1965 L-320 #L320 013642 (the misspent ute)
1965 L-320 (Still in CA)
http://datsun_marc.tripod.com/cgi-bin/Datsun_homepage.html
Sisterdale TX
|