List...thanks for all the replies and advice -- +20 it is.
Cheers...Michael
-----Original Message-----
From: owner-datsun-roadsters@autox.team.net
[mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of Teesun68
Sent: Sunday, January 28, 2001 4:19 PM
To: Roadster List
Subject: Fw: Engine block bore
Hey gang,
Back from a few months of absence when we relocated from one end of the
country to the other- but the old '68 1600 came with us --- in many,many
parts. I'm now getting the engine block machined and the shop came back to
me
with some numbers - worst cylinder taper is 3.5 thou. The recommended
solution
was a re-bore to take +20 thou. pistons. That somehow seems excessive to me
although I have 0 experience in these matters....(what else is
new--hee,hee,hee ) For those who have dealt with such matters - does this
sound reasonable? Can +.0035 not be taken up with a different size rings
without having to go to +.020 pistons? Any help/comments would be
appreciated.
Thanks!
On a different note, I found this site when surfing around - now sure
how
good it is or anything about it, but I thought I'd pass it on to the list.
https://secure.formysite.com/nissanautoparts.com/database/
Cheers...Michael
'68 1600 stripped to the bare frame.....
|