The later Zs (72 and later) and 510s had 2 piece casings w/an integral bell
housing attached as the 4 speed is.
>From what i have read the gears and other parts are not interchageable. They
are close but no cigar!!!!!
66 Mike
----- Original Message -----
From: Kyle Hagemann <kwhcpa@addler.net>
To: John F Sandhoff <sandhoff@csus.edu>; <datsun-roadsters@autox.team.net>
Sent: Monday, September 11, 2000 6:53 PM
Subject: Re: Transmission gear swapping
> > The Roadster tranny is unique onto the R and U engines. So I know
> > that a 510 tranny isn't a bolt-up swap because of the bellhousing and
> > who knows what else (length? starter location? Whatever). BUT..
> > are the internal designs similar? Can I pull the internals from a 510
> > box and put them into a Roadster box? The 510 has two different ratios,
> > one that matches our Roadsters and another, lower ratio. I haven't
> > compared part numbers on the fiche yet; that'll probably tell me, but
> > has anyone out there successfully done such tinkering?
> >
> > -- John
> > John F Sandhoff sandhoff@csus.edu Sacramento, CA
>
> Hi John-
>
> I've wondered this too, especially as the Z units seem to be more
> common (read=inexpensive) than the roadster trannies.
>
> Way-back-in-tha-day, before the 5speed 280Z's came along, it was
> not unheard of to put a roadster trans in a 240Z. Building theory
> on hearsay (heresy?;-) it stands to reason that the L bellhousing
> can be swapped with the U/R bellhousing... (I can hear someone out
> there thinking, "U/R silly!")
>
> I have it first hand from a local Z dude that the servo-type roadster
> five speeds appear nearly identical to the BW-type Z units. 'Course,
> things can look a lot alike and still be incompatible.
>
> So I dunno! But it seems that you could put a Z/ZX/510/PU/200sx/etc
> trans into a roadster with a bellhousing swap. But it's likely more
> complicated... bearing bores and shift rod holes have been mentioned
> as a stumbling block when converting a CA tranny to L-series duty; I
> wouldn't be surprised to hear that similar shenanigans are required
> for a L->U/R swap.
>
> Anyone have some of ye olde Z-carre hop up manuals from the mid/late
> 70's hanging about, and/or have first-hand knowledge of what it takes
> to get a roadster unit in a Z? That tech oughtta be backwards-
> compatible with a Z->roadster swap.
>
> 'Course, I've just shelled out the bucks to fix my Roadster 5spd, so
> there better not be an easy L-tranny swap;-D
>
> HTH
> Kyle
> still broken
>
|