Hi all,
I have a question. How freely should a crank spin in the bearings when it
is all torqued in? This is for a L20b engine but I would think the U20 or
R16 would be the same. I just got it in and I can spin it but it takes some
effort. I think the center bearing might be a little to wide at the "thrust
faces?" of the crank.
Any reply would be greatly appreciated. I don't want to leave it if it will
rip up the engine when I start it up.
Thanks,
Matt Peterson
68 1600
Zimmerman, MN
________________________________________________________________________
|