I just installed part# SB3824 front and rear, working fine so far.
BZ
>From: Ray Cole <raycole@mindspring.com>
>Reply-To: Ray Cole <raycole@mindspring.com>
>To: laurahoey@myself.com, Datsun <datsun-roadsters@autox.team.net>
>Subject: Re: Speedbleeders
>Date: Mon, 01 May 2000 20:41:53 -0700
>
>I have had them on the rear of both of my roadsters and on the clutch slave
>cylinder for two or three years now.
>
>The fronts take a different length and I never followed up to see if
>Speedbleeders made ones that would fit.
>
>The good: great for flushing your system and for minor bleeding
>
>The bad (maybe not bad, just limitations): they don't work with a system
>with a LOT of air in it, you have to get most of the air out before they
>function
>
>one of mine kept oozing brake fluid
>
>Overall they are worth while and I would like to put them on the front also
>
>Ray
>
>
>At 11:13 PM 05/01/2000 -0400, laurahoey@myself.com wrote:
> >Some time back there was discussion about Speedbleeders and several folks
>indicated they were going to install them. How's it going? Do you like
>them? What size did everyone go with? TIA!
> >
> >Laura Hoey
> >'70 2000
> >NOWROC
> >
> >----------------------------------------------------------------
> >
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
|