Hello All,
After doing some reading on the subject it seems like a MIG welder
is just the thing I need. To re-cap, in case I am wrong, I want something that
can be used to weld up sheet metal on my datsun roadster. I also want
something that I can use to weld up mild steel tubing and aluminum, which
the m.c. frame I am hoping to build will be constructed from.
From my reading I think that I want to go with the actual gas and
not flux-cored wire. Can you all reccomend different welding units to me??
There seem to be a large amount of manufacturers out there. I know I want
something that runs on standard 120V's. How much power do I need?? They
all seem to be rated like, 'welds up to 1/4 inch in one pass'. What features
should I look for/stay away from??
I will probably try to buy a used unit if I can find a good one locally.
Any info would be greatly appreciated.
Thanks,
Daniel Neuman
SF CA USA
415-752-3291
|