Wear
in the throttle shaft can also cause this, as the butterfly slips
out-of-center in the body. You can re-center the plate, but it's a real
pain getting the screws loosened up, as they're usually peened over.
Toby
sbutner wrote:
>
> Nathan,
> this sounds alot like the problem I had with My 1600 carbs. I couldn't get
> the idle below about 1200 RPM except when I pushed on the linkage. (As with
> yours, my throttle Cable also had plenty of slack). My problem turned out
> to be with the front carb throttle plate hanging up on the side of the carb
> body.
|