Does anyone have experience fabricating and installing the section of the
firewall that supports the brake and clutch master cylinders? On my 65
1500 the area that supports the clutch master is completly broken away it
was patched with a piece of 18 guage steel and a turn buckle by the PO. also
the brake area is showing stress cracks. I am getting ready to have a new
panel fabricated for this section and was wondering if anyone else has done
this and may have some suggestions on how to do it? I checked with Stan
Chernoff but he only makes the supports for the High windshield cars.
Thanks
Duram
SPL-310
|