-----Original Message-----
From: Ross <SROSS@ex-pressnet.com>
>I have been restoring a '69 2000. Before re-installing the dash I
>want to make sure that all gauges etc work. The temp gauge does
>not move.
>1) Is there an easy way to isolate the problem (gauge, sensor,
>wiring, etc)?
Kinda, yeah. Ground the sender wire, the gauge should move to HOT.
>2) Where is the temp sensor located?
On the thermostat housing, underneath the thermostat, facing the rear
of the engine compartment.
>Additional question: the labels I put on the wires to the voltage
>regulator on the right side of the steering column came off. Does
>it matter which wire goes where, if so how do I tell which is
correct?
I'm sure it does matter. I'm guessing, but there's probably four or
five wires? Two will go to the alternator, one will go to a key-on
12v+, and maybe a ground... get a wiring diagram and trace the
wires, shouldn't be too hard to do.
HTH
Kyle
|