Hi,
Wow I had not heard this..I talked to Dennis at CDM a while ago and
he did not seem to think it was any big deal. Are we talking about the same
thing?? I have a complete 4.11 lsd unit that I am going to swap out for my
stock 3.7. Maybe I am confused..its already built toghether and ready to go?
I was under the impression that I would jsut unbolt the drive shaft unbolt
the 8 million bots around the pumpkin and bolt in my new unit?? The drive
shaft should bolt right back up and then I would jsut have to slide the axles
back in??
Whoa, somebody clear this up before I go and destroy this thing.
Daniel 69 2000
> DROPPING THE REAR END AND INSTALLING A NEW RING AND PINION ARE NOT AS SIMPLE
> AS THEY SOUND !!!!!!!!!!!! The new gears have to be set to exact tolerances
> in order to mesh properly and avoid wear and heat . Most mechanics dont have
> the tools to do this correctly and I feel sure that none of us do either .
> Have you ever heard the statement That " REBUILDING ENGINES IS EASY ! I DO
> MINE EVERY MONTH " at the risk of sounding like an ass , if you choose to do
> this yourself , we will probably be hearing about your next attempt fairly
> soon . I had roush racing here in charlotte set up mine (4:11 limited slip)
> for about 250.00 labor . Thats much cheaper than buying new gaers ,
> differential , and bearings again .
> Just my opinion . . . . Good luck either way . .
> Randall
>
|