I'd agree,
and have a Century 105 that also does pretty well. It was inexpensive,
but works as well as the Hobart...
Toby
David Urschel wrote:
>
> Robert,
>
> I have the same Lincoln setup described by Don. Highly recommended.
> Don't buy a cheap MIG welder, you won't get good results on thin
> automotive sheet metal. (I ended up sending one back as it would not
> function properly at the low power settings required for thin sheet
> metal). I have used Lincoln and Hobart machines with success. Forget
> about stick welders for sheet metal. As Don said practice, practice,
> practice.
>
> David Urschel
> srl311-10465
|