On my 68' 1600 that has just finally reached the floor rather than being on
it's old friend, the BLOCKS, I start it up, and press the clutch, and it
won't engage. So, I clean out the hardline from the master cylinder, and
also the tank of the Master, and then bleed and bleed again, to make sure
NO air bubbles are in. I refill fluid, and then give it another try. But
it won't engage again. I have a STRONG feeling that my master cylinder is
not functioning like it is supposed to... So, what do i do now? Do i have
to repair the master AND slave cylinders for the clutch, or can i just fix
the Master?? Also, my brakes are like, locked on the wheel. I pushed them
to activate them, and after a few pumps they grab, and then stay that way.
I rolled the car back and forth, to loosen them a bit, and it worked, but
just a little bit. So... what can I do to fix this?
And, last but not least, where can I find a HARD top?
Thanks people!!
|