Carl,
I will leave the electrical part of the question to the guys on the list that
are really good at that....
You may be able to get the front screws out of the windshield with an angled
screwdriver, OR try a screwdriver tip that has a hex head (fits in the
multi-use screwdrivers) and a small box end wrench the right size. Use some
penetrating oil on it first, like a day ahead of time. If you do have to
remove the windshield, you cut the old seal off with a sharp utility knife.
The new ones cost about $100 and you put them back in by wrapping a rope
around it, then pulling the rope through into the inside of of frame. Email
if you end up doing this.
Welcome to the world of Roadsters!
Joseph Berkenbile
70 1600
Albuquerque
|