My experience is with a 68 2000, same thing I think.
I removed the control knobs and the screws (3) from the dash side and while on
my back-upside down, I wiggled and moved the controls until they finally came
out.
The defrost horn was alread removed... but nothing else had to taken out.
Good luck
JLB
(small hands and all)
In a message dated 2/23/99 6:12:51 PM Eastern Standard Time,
MillerD2@idhw.state.id.us writes:
> I have taken out the heater core and am trying to remove the controls from
> my 68 1600. From just looking underneath it seems to be hanging up on the
> wiper motor. If so does one need to remove the wiper motor completely or is
> it a loosen and shimmy it out of the way?
>
> Don Miller
> 68 1600 (with the VG30ET sitting inside the engine compartment now!)
> Meridian, ID
|