That's about the best way...may need a bit of heat as well.
Herb
On Mon, Nov 30, 2009 at 1:48 PM, Glenn A. Merrell - TSN <
StagByTriumph@triumphstagclub.org> wrote:
> Jimttx wrote:
>
>> I am stripping the block so it can be cleaned. Is there an easy way to
>> remove
>> the freeze plugs?
>>
> Hi Jim,
> I used to use a screwdriver hammered through the center and popped out.
> Now I drill a hole in the middle, insert a threaded end on a slide hammer
> which works more cleanly.
>
> --
> Glenn Merrell
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Buick-rover-v8@autox.team.net
http://autox.team.net/mailman/listinfo/buick-rover-v8
http://www.team.net/archive
|