----- Original Message -----
From: "Larry list account" <list@marketvalue.net>
To: <mgb-v8@autox.team.net>; "'Buick-Rover V8 Group'"
<buick-rover-v8@autox.team.net>
Sent: Tuesday, November 11, 2003 6:41 AM
Subject: RE: Correct way to install Felpro Head Gaskets
> > Don't think mine were Felpro, but they were marked 'TOP'.
>
> Paul, Al's friend is also my friend. I too spoke to him about his
gaskets.
> Turns out his gaskets don't say 'top' or 'front' or anything. So the
> installation procedure is a bit of a mystery.
>
> I suggested to him that the metalized side goes to the 'hot' side, which I
> would believe to be the heads. But frankly I am not sure.
>
> Larry
>
Paul,
The next question would be: Is the side marked 'TOP' metal? I'm assuming
that the gasket you are using is a composition rather than a steel shim.
Al
///
/// buick-rover-v8@autox.team.net mailing list
///
|